LED the way in the process of use, not after the installation is over, the need for normal maintenance work to make the LED street lamp product performance, how to maintenance of waterproof, here we are finishing the relevant specification.
LED street lamp manufacturers of LED street lamp with conventional street lamps, the LED light source adopts low voltage dc power supply, by GaN power type synthetic efficiency white light, blue light leds and yellow is efficient, safe, energy-saving, environmental protection, long service life, fast response speed, high color rendering index of unique advantages, can be widely used in road.
Housing available, resistance to high temperature of 135 degrees, low temperature resistant da
Manufacturer of LED lights ED street lamp light is higher than high pressure sodium lamp many color, high pressure sodium lamp only around 23, color rendering index and the LED street light color rendering index above 75, think in terms of visual psychology, to achieve the same brightness, LED street light can, on average, more than 20% lower than the high-pressure sodium lamp.
How to maintain the LED street light?
Solar panels, for example, in the usual maintenance, check the orientation Angle of solar panels, branches, leaves, or other direct blocking objects.
Whether in the shaded area of other objects, whether to have cracks, ashes, the dirty surface of the light.
Monomer is cracking, problem is flat, all in the range of detection.
In LED street lamp used in the system, the maintenance of batteries, the most difficult for normal battery service life is 2, 3 years or less of the battery charge and discharge should be regular inspections in its life cycle, and observe to the electrode or wiring whether corrosion or bad contact.
This is the main LED maintenance work.
How to use the LED street light waterproof?
For sealing is must pass the lamp holder, lamp holder of waterproof treatment can ensure the service life of street lamps, so the street lamp shell selection is very important.
Pattern is important to note that when choosing whether to have waterproof performance, for the controller at the time of installation is usually on the inside of the road, and thus avoid the sun better.
Is to have a certain degree of waterproof performance, for the installation of the battery, is the battery is buried in the ground, around 40 cm, to avoid flooding.
Finally, to test the LED street light head, see the street light is normal light, if light can be normal use, if not you will need to be replaced.
Basically, the related instructions about how to maintain the LED street lamp and waterproof work instructions, if there is a problem, you are welcome to inquire, we will continue to update for you related instructions.