Sunfree Lighting Limited is a high-tech manufacturer specialized in R&D and production of solar led street light

LED lights installed correctly related regulations

by:SUNFREE     2021-02-04
In the process of installation of the LED street lamp, standard installation way is to make sure we correct use of premise. LED street lamp manufacturers of LED street lamp with conventional street lamps, the LED light source adopts low voltage dc power supply, by GaN power type synthetic efficiency white light, blue light leds and yellow is efficient, safe, energy-saving, environmental protection, long service life, fast response speed, high color rendering index of unique advantages, can be widely used in road. Housing available, resistance to high temperature of 135 degrees, low temperature resistant da 45 degrees. LED street lights maintenance costs low, compared with the traditional street light, LED street lights maintenance cost is extremely low, through the comparison, can recover all input costs less than 6 years. LED street light automatic control and energy saving device, can realize to meet the requirements of different times lighting cases, most likely to reduce the power, saves the electricity. Can realize the computer dimming, period and control, light control, temperature control, humanized functions such as automatic inspection. In the following, we introduce the specifications of the LED street light should be paid attention to the correct installation. First of all, the same way ( From the light source to the ground) LED street lamp installation height, Angle and the direction of the light should be consistent. Excavation size should comply with the design specification. Based on concrete strength grade shall not be lower than C20. Foundation of the cable sheath should be through the foundation center, and should be more than 3050 mm base plane. Before pouring reinforced concrete foundation must be removed from the pit water. Used to install the LED street light metal parts, such as lamp, lamp arm, hoop, bolts and linking piece, should be hot dip galvanized. Coating quality shall be in conformity with the relevant provisions of the current national standard. Longitudinal center line of LED lighting installation should be the same as the longitudinal center line of lamp arm. Levels of lamps and lanterns should be parallel to the ground, horizontal visual after fastening should not be tilted. LED fixtures are fixed and firm, adjustable lamp should adjust to the correct position according to the design, lighting wiring should conform to the rules. LED lights arm, light plate, light pole without connectors. Perforation of the mouth or tube should be smooth without burr. Insulation casing or the bandage should be used. The length of the bandage should not be less than 200 mm. Tighten all kinds of nuts, increase gasket and trampoline. After fastening nut shall not be less than two pitch. Above is on the correct installation of LED street light specification, if there is a problem, welcome to inquire, we continue to update more related instructions, you can pay attention to our website for more information.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
Thank you for your enquiry. We will get back to you ASAP